
Page 2 Installation Instructions: AM-650 1/4" Streaming Tape Drive
PDI-00650-00, Rev. A00
The AM-650 has the same environmental specifications as your computer.
The AM-650 is supported only on the SCSI-2 bus (either narrow or wide). It is not supported on
the SASI bus found on older AMOS computers.
TOOLS REQUIRED
For most installations, the only tool you will need to install the AM-650 is a #2 Phillips-head
screwdriver.
PREPARING THE AM-650 FOR INSTALLATION
Before installing the AM-650, you should make sure its configuration jumpers are set correctly. These
jumpers are found on the back of the tape drive, as shown in Figure 1. Specifically, you need to set the
jumpers determining the SCSI ID for the drive, and make sure the termination jumper is set correctly.
The next few sections discuss SCSI IDs and SCSI bus termination.
Comentários a estes Manuais