Alpha Microsystems AM-649 Manual de Instruções descarregar pdf (Página 16)

Installation Instructions: AM-650 1/4" Streaming Tape Drive Page 13

PDI-00650-00, Rev. A00

DWF-20652-00

MOUNTING RAIL

Figure 8 - Attaching Mounting Rails to Peripheral

Once the rails are installed, slide the tape drive into its mounting position in the chassis. Attach the

power cable from the power supply to the four-pin connector on the drive.

Attach the Wide SCSI cable to the 68-pin connector on the drive. The drive’s connector is keyed so the

cable can only be attached correctly.

If you are attaching the drive to a 50-pin narrow SCSI cable, you must use an adapter between the

50-pin cable and the 68-pin connector on the drive. This adapter is provided with the AM-650.

Eagle Deskside Chassis Installation

Complete instructions for installing SCSI peripherals are included in the service manual for the Eagle

and AM-6000 deskside computers. Use these instructions to install your AM-650 tape drive and then

use the instructions in this document to complete the software portion of the installation.

SOFTWARE INFORMATION

There are several points to remember when using the AM-650:

•

The AM-650 works only with AMOS 2.3A or later.

•

You can have one or two streaming tape drives attached to your computer system.

•

A single streaming tape drive must be referred to as STR0:. If you have two drives, the one with

the higher SCSI ID must be STR0:; the other is STR1:.

•

The device driver program, STR.DVR, must be loaded into system memory.

•

If you have an AM-650 on an Eagle or Roadrunner computer which doesn’t use a CMOS

configuration menu, and you want to be able to warm boot from it, it must be set to a higher

SCSI ID than any other tape device on the SCSI bus.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Sem comentários

Alpha Microsystems AM-649 Manual de Instruções Página 16